 |
|
||||||||||||||||||||||||||||||||||||||||||||||||
 ACCRETECH Prober Training Course 2010 January to December, 2010 Training Course for Taiwan
Training Hours: Mornings 09:30~12:00 - Afternoons 13:30~17:30 Please register early to guarantee your spot. Training Course Contents: Operation, Maintenance/Adjustment Debugging/Troubleshooting 1.Operation: (Two-day course) 1-1. Operation principle and main function introduce 1-2. Probe startup procedure and configuration introduce 1-3. How to create new device 1-4. Configuration, Operation, Device store for backup 1-5. Demo run for application 1-6. Broken wafer setup 1-7. Marker setup by pass/fail, category and double ink. 1-8. Map setting (pass/fail, category, coordinate) 1-9. Map out put procedure 1-10.Map in put for marking machine, multi pass probing by lot end 1-11.Multi pass probing before lot end 1-12.Needle cleaning function 1-13.Setup group index device 1-14.Needle mark inspection 1-15.Fail Mark Inspection 1-16.Device/operation parameter explains. 1-17.Q &A time 2. Maintenance: (Two-day corse) 2-1.Maintenance/Adjustment 2-1-1. Probe facility request 2-1-2. Probe structure introduces 2-1-3. VME box introduces (control board, power supply, fuses, servo driver) 2-1-4. Main body and loader unit sensor adjustment (air, vacuum sensor, safe, center sensor) 2-1-5. Daily, weekly, half year, year PM procedure 2-1-6. X,Y,Z, Theta, F axis axis home sensor and Z phase Introduce. 2-1-7. X,Y,Z, Theta, F axis trouble shooting procedure 2-1-8. X,Y axis Lissajous wave figure adjustment 2-1-9. X,Y servo adjustment 2-1-10.Chuck & clean unit top flatness check and adjustment. 2-1-11.Camera system introduce & calibration 2-1-12.HDD driver replace & software install 2-1-13.EPROM & software version 2-1-14.Q &A time  |
 
Susan_lai@spirox.com.tw Tel. +886-3-5738099 ext. 2908 |
||||||||||||||||||||||||||||||||||||||||||||||||
